The best way to avoid a costly garage door opener repair job is to make sure you do the proper upkeep and maintenance. If a problem should result, you can try to troubleshoot and fix it yourself. Some of the problems that may result that you can troubleshoot and possibly fix are:
- The remote doesn’t work, but the wall switch does
- The wall switch doesn’t work, but the remote does
- The door goes up with the remote, but only goes down with the wall switch
- The lights don’t work
Before something breaks, if you keep up with the maintenance of your garage door opener, and periodically do an inspection, this will lessen the chances of something not working which may avoid a costly repair job.
What type of opener do you have?
The first step in maintaining your garage door opener is to know what type of opener you have. There are basically three types of drives: Chain drive, belt drive and screw drive. Chain drive systems are the most common. A motor and pulley system is attached to the chain which opens and closes the door. The belt drive uses a rubber belt instead of a chain. A screw drive system uses a long threaded rod to open and close the door.
How do you perform a visual inspection?
The basic maintenance procedure is to do a good visual inspection of all moving parts. Lubricate the chain and other parts on a regular basis. Visually inspect all moving parts. If a part is loose, tighten it as needed. Lubricate the chain with WD-40 and spray all moving parts at least once a month. Make sure the door moves smoothly and doesn’t get stuck during closing or opening.
Remote not working?
Troubleshooting and fixing a problem by yourself will definitely save you a costly repair job. If the remote doesn’t work, but the wall switch does, first replace the batteries. If it still doesn’t work, try getting another remote made for your particular garage door opener model. If that doesn’t work, you may need to replace the receiver which comes with a new remote. The cost should be under $100.
Is the switch broken? Did you check the wires?
If the wall switch doesn’t work, but the remote does, try replacing the switch. If that doesn’t work, the wire that connects the opener to the switch is probably bad. Just simply install a new wire. If that still doesn’t work, you might need professional garage door opener repair Marietta GA.
Another problem that may occur is the door goes up with the remote, but only goes down with the wall switch. Check to see if the safety sensors are aligned. When nothing is between them, the light on the sensor should be lit. If it isn’t, replace the sensors. They should cost around $50.
If the lights don’t work, replace the bulbs. If this doesn’t work, the light socket is probably bad. Simply unscrew the circuit board from the unit. Unclip the sockets and replace them with new ones. You should spend about $15 or $20 for sockets.
For garage door opener repair, these are just a few of the things that you can fix yourself. The main point here is to maintain and inspect your system, and try to troubleshoot and fix a problem yourself before you call a repairman. Doing this will save you a costly repair job.
No time to guess? Too complicated?
If you don’t have the time or resources to repair a garage door opener yourself, call your experts at All Four Seasons Garage Doors. Don’t forget that we are home of the $20 service call! For just $20, our experts will inspect the opener, diagnose the problem, and give you a price quote. If you decide to have them repair, the initial $20 will count towards the total bill.
Think about it – would you rather spend $100 on a new receiver and remote just to find out that the problem is somewhere else, or would you rather have us inspect it for you?
For more information or to schedule an appointment, call All Four Seasons Garage Doors today at 678-981-8454.